Dust Proof Electrostatic PE Protective Film 0.03mm Clear Polyethylene Protective Film Roll for Aluminium Window Frame Protection

Dust is not the only enemy of a finished aluminium window frame. Between the anodising bath and the moment the glazier unwraps the frame on site, the profile passes through cutting, drilling, packing, container loading and unloading. Each of those steps drags grit across the surface, and every grit particle leaves a line that a customer will notice under showroom lighting.

This 0.03 mm electrostatic PE protective film is engineered to sit between the profile and that traffic, absorbing abrasion while a clean, non-adhesive cling holds the film flat against the metal. The film is cast from 100% virgin polyethylene, so it stays soft and pliable at the low thickness while keeping the mechanical strength needed for high-speed lamination. Because the bond is electrostatic rather than glue-based, the roll clings to smooth aluminium, powder-coated steel, stainless sheet and acrylic without a single drop of adhesive, and it lifts away in one continuous piece when the protection period is over. No gum lines, no ghost marks, no solvent wiping before the next process.

• Electrostatic cling, zero adhesive: The film is charged during winding, so it grips the profile through static attraction only. Nothing is transferred to the metal, and the surface needs no cleaning after peeling.
• Dust barrier from extrusion to installation: Rolls are wound and sealed inside a filtered workshop, so airborne dust cannot settle on the contact face before the film is applied.
• 0.03 mm calibrated gauge: Thickness tolerance is held across the full roll width, which keeps tension even and prevents wrinkles, air pockets and edge lift on long profiles.
• Scratch and scuff resistance: A tough outer skin handles stacking contact, saw tables and pallet corners, protecting anodised, brushed and powder-coated finishes.
• Controlled peel strength: Low-tack electrostatic bonding releases cleanly after three to six months of indoor storage, which matches the normal fabrication and shipping cycle.
• Slit to your width: Rolls are produced from 100 mm up to 1,000 mm, with one-inch, two-inch or custom cores, so the film fits your existing laminating line without rework.
• Transparent inspection: Installation teams can read part numbers, anodising batch marks and surface defects through the film without removing it.

• Aluminium window and door profiles protected straight after anodising or powder coating, so the frame arrives on site free of transit marks.
• Stainless steel and brushed metal sheets that pass through laser cutting, press braking and welding while the finished face stays untouched.
• Coated furniture panels and appliance housings stored in busy warehouses where forklifts and cartons do the damage.
• Acrylic and PVC display panels that must reach assembly without a single fine scratch.
• Glass units handled on framing lines, where the film works as a temporary dust and scuff barrier until glazing is complete.

Because one supplier covers aluminium, stainless steel, coated metal, acrylic, PVC and glass, purchasing teams can standardise on a single film and cut the number of incoming material codes they manage.

Every roll is wound on a rigid core, wrapped in protective PE and packed in an export-grade carton. Pallet packing with edge protection is available for container loads, and each carton carries the batch number, thickness and width so receiving teams can verify the delivery against the purchase order in minutes.

Thickness, peel strength and width are checked on every production batch, and third-party test reports for ROHS and REACH are issued with the shipment on request.